Answer to question regarding sticking sliding glass patio door.
How to fix sliding glass door that sticks.
Remove the sliding door.
This will actually help to move around the lubricant into the harder to reach middle area where the door is constantly sliding and experiencing the friction that makes it stick.
Here are the basic steps.
The tracks are notoriously difficult to clean so you ll have to pull out all the stops.
Who can i contact to rebuild my sliding doors.
Use hot soapy water and a brush to clean the tracks.
Lastly remove the sliding glass door panel.
Are there contractors who specialize in this service.
Standing inside the house with the door in the middle of the opening have your helper on the opposite side slowly tilt the top of the door toward you.
I live in ocala florida.
Determine exactly where the door is sticking before deciding on a remedy.
Inspect the rollers and replace them if damaged.
Reinstall the doors and adjust the rollers to the correct height.
This little fix took all of five minutes but it made a night and day difference to my everyday routine to let charlie in and out of the house which she wants to do all the time.
Most of the time the problem stems from dirty and dried up rollers.
Move the door back and forth like you did in step 1 to help the door glide over the oiled areas.
Hi frank thank you for contacting the glass detective with your concerns over how best to approach the repair of your patio doors.
These rollers can become damaged dirty or broken as the years go by and cause your door to stick.
Pry off or unscrew the covers and then adjust the rollers using a screwdriver so that they move away from the door.
If the edge of the door is hitting the frame try tightening the screws on the top middle or bottom hinge on both the door frame and the door being careful not to over tighten and strip the screws.
If only combating her nonstop shedding.
With the screws brackets removed pull the fixed glass panel from the side of the frame towards the middle of the door lift and swing the bottom out of the frame and then remove the whole door panel.
To do this lift and swing the bottom out towards the outside and then remove it.
To fix this remove your door from the tracks clean out the rollers and spray them with a lubricant such as wd 40.
Sliding door tracks are magnets for dirt dust pet hair bugs grass food crumbs you name it.
This will allow you room to remove the door.
Next take a dry stiff scrub brush and work through corner to corner.