If you hear a click the lock is disengaged and the door should open freely.
How to get into a locked door.
When you insert the bent paperclip stick the straightened paperclip beneath it and move it around.
Gently insert the screwdriver s flathead into the door knob s slot then turn it counterclockwise.
With many older doors you need to pressure the door as you fiddle with.
Unless you plan on.
Bend one of the paperclips and fold out the other one as straight as possible.
Ideally you should consider drilling your lock after you have exhausted all other bypass methods to unlock a door.
There s no universal standard for which way a key turns to unlock a door.
If the locking mechanism is a latchbolt the kind of bolt that is spring loaded and has one angled edge and the angled edge is facing away from you you can hook it with a wire hanger.
Lift your dominant leg at the knee.
Stand in a solid stance.
Opening a jammed lock 1.
Drilling a lock is a form of destructive entry.
Twist the wrench to see which way has more give.
Put them in a tight chokehold drag them over to the.
You may also need to tilt the knife a little till you find the suitable angle for moving the lock.
Once you ve hooked the doorknob take hold of both ends of the cable and pull back and forth and try to turn the doorknob.
Kick the lock on the door with the bottom of your.
This too can take a few minutes but just push on the door a little and be patient and you should be able to turn the door knob and be back in your room.
Make sure that it is placed on the opposite end of where the key s teeth grooves that move the key pins would go.
Begin by inserting the tension wrench into the keyhole as if it were a key.
Be careful not to exert too much pressure here.
Push or pull the door as you turn the key.
Apply pressure on the lock using knife and push it back in the door.
If you have two paper clips on you the process will be that much easier.
Turn the key both directions.
To open these locked doors you ll need to take a nearby enemy hostage by sneaking up on them or knocking out their legs with a bullet or two.
Squarely face the door with your feet roughly shoulder width apart knees slightly bent.
The tools required for drilling a lock are an electric or battery powered drill a drill bit a suitable lubricant and.
After some wiggling your lock will hopefully open.