I m sure you ve seen bearskin rugs etc same concept.
How to hang a deer hide on the wall.
Puncture the hide from the back 1 in from edge perpendicular to the edge of the wood panel.
It serves as a background sorta speak.
Tie off and clip off the end.
Do this every 4 5 or so.
You would make a large rectangle frame out of tree branches or wood trim and lace the hide to it with leather shoe laces.
How to hang a deer hide on the wall unless the hide is a designer piece of art you may need to prep the pelt before hanging.
You could just unlace it roll it up and hide it away pull it back out and lace it up again.
Another option is to glue the whole hide to another piece of material that has been cut a little bit larger then the hide itself and then hang the whole thing.
Finish off the nailing by dispersing them around the perimeter of the hide to secure to the wall.
Line up the puncture with the edge of the panel and drill 1 8 hole.
You can either run the wires through the wall or just run them against the wall down to the floor and along the floor to the corner of the room.
Run the tie up through the panel then through the holes in the hide.
Using a grommet machine designed to cut through leather and either brass or copper grommets carefully install the hardware around the perimeter of the hide about 12 inches apart.
You would cover the wires that run down the wall with a covering that you can paint the same color as the wall so it stays hidden.
One method i have seen taxidermists use on rugs that are ment to hang on the wall sew on small rings to each point where it would need to be supported.
Start nailing the cowhide skin onto the wall and hold your hands around the cowhide s centre point and gather up the cowhide skin and climb the ladder.
You may have to redo a few nails if the hide starts to buckle or bend.
You could use a ring from a key ring or even.