The aluminium suspension system can also be used for a rope suspension.
How to hang a laminated wall map.
The frame is put onto the back of your plate with the included glue.
If your poster or map is too heavy for this method you can do a similar thing on the front.
We ve listed our favourite ways to hang our wall maps below but before you start take a minute to properly prepare your map.
A couple of rolls should do it but please be careful.
One end of the rope is hooked under the rail of the plate.
Then it has to rest for 24 hours before hanging it up.
Pull it out of the tube and lay it on a clean flat surface.
You don t need any additional materials.
Dry fit to the foamcore clip one short side of the map to the short edge of the foamcore.
At the time of publication the most recent version of the national geographic world map mural is 2013.
The directions on the package were sufficient for us.
Check the fit and alignment.
The mural is actually three latex coated panels that are hung like wallpaper.
Place the command strips along the edges of the foam board s backside.
Then let the map roll up.
Spray the adhesive to half the board then unroll.
Use two nails or screws in the wall to hang up your print.
I knew i would have to buy some wallpaper hanging supplies but i didn t anticipate that they would cost almost as much as the mural.
Put tape on the front of the corners all the way to the edge and then tape it to the wall but put the tape over your laminated corner.
Use tacks but only put the sides of the tacks on it not the point.