Apply the glue to the mirror in staggered strips keeping 5cm from the edge.
How to hang a mirror on a wall with string.
Make sure there is no grease or moisture on there.
Carefully tilt the mirror back so it rests flush against the wall.
Then firmly press in place all around using a dry cloth or towel.
Screw on the rest of the top clips to secure the mirror against the wall.
Center it under the top of the mirror and hold it up tight under the wire until the wire is taut.
Take a small piece of wood approximately 12 inches 30 cm long and mark its center.
Molly bolts are a medium weight hollow wall anchor.
To use drill a pilot hole then tap the entire bolt sleeve and screw into the hole until flush against the wall.
Slide the mirror into the bottom clips.
Place a scrap piece of wood that is approximately half as long as the mirror is wide underneath the hanging wire on back of the frame.
Leave to dry before fixing the mirror.
Hold the mirror against the wall at the desired position.
Set the mirror down.
Thoroughly clean the wall tiles.
Mark the location of the top edge and the center of the frame.
Place the mirror against the wall and check again that it is level.
Tighten the bolt into the wall to expand the anchor.
Once you have hanging hooks mark where you want to hang the mirror on the wall and drill a hole for the hook.
Determine the position of the two fasteners with a block of wood.
Fit the other pieces of the top clips into the top brackets and screw them together just enough to firmly hold the mirror in place.