Diy plate hangers find the center of the item to hang on the wall place your pop tab so it will not show over the edge of the plate follow the directions on the glue packaging hang when the glue is cured.
How to hang a very heavy platter on wall.
The best way to do this is to first attach the plate hanger to the plate and lie the plate on a flat surface.
I did need to remove one disc from a plate i hung it upside down and didn t realize it until it had dried for 24 hours.
Hold the plate at.
After 24 hours hang them up with by the hook on the disc to a nail in the wall.
Set the plates in a cool dry place for 24 hours to dry.
Slide the bottom plate hanger mount through the bottom of the looped spring and pull the spring until you can slide.
The top of the hanger should barely touch the flat surface that your plate is lying on.
Get a medium gauge picture wire and cut a little less than twice the distance between the two metal hangers.
For the oval platters which have edges that round up like a bowl i used two hooks each turned sideways and i flipped the hooks to create a hole for the nail.
Firmly rub the disc with your fingertips or a slightly damp towel to remove excess glue or air bubbles.
You can move them around as you please and the discs stay secure to the plates.
Secure each end of the spring on a spring loaded wire plate hanger kit to the two ends of the top wire plate hanger.
Allow to dry overnight.
The key to working with these hangers is to bend the top of the hanger so that your plate will lay flat on the wall once hung.
If your picture is wider than 16 inches 40 6 cm or the distance between two studs in your wall use a level and two screws to screw a narrow piece of wood into the wall.
You need metal holders that are sold in hardware stores.
For each plate measure the distance from the top of the plate to the wire that will catch on the hook behind it then nail a hook into the wall that same place on your taped outline of the plate.
If they are too short to go around your platter they can be extended by using extra wire pieces.
To hang i used a twist tie to secure the round platter to the nail in the wall.
Make sure the screws are in at least two studs for extra strength.