Use a small amount of the excess mortar and spread it onto the back of a tile with the notched side of the trowel.
How to hang large tile on shower walls.
Determine how much tile you ll need.
Spread thin set along the first section of your tile row.
Stagger large format tiles in thirds.
Install full piece tiles first and fill in with cut pieces as you go or install them at the end.
Measure each wall area calculating the width times height.
If you wait to install the cut pieces use a notched trowel to scrape the thinset from the wall so it doesn t dry before.
One way to limit tile lippage is to stagger large format tiles into thirds.
Turn over the trowel to the notched side and comb over in one direction.
The staggering of tiles in thirds helps limit this effect.
Add up the wall areas and add 10 so you have extra tile for mistakes or future repairs.
Before applying your tile to the wall decide on the layout and orientation of your tile by positioning the tiles on the floor.
You ll need a design plan before you start attaching the tile.
Set the tile panels on the side walls with thinset the same way as for the back wall using the starter board.
For our shower we chose a running bond pattern.
Dry lay the panels and measure them to see where you need to make cuts.
Measure the width of the shower walls on either side of the door.
Run a damp sponge over the backer board in the area you intend to tile.