Hang first strip start at your plumb line and ensure the pattern is right side up.
How to hang wallpaper on a textured wall.
The arrow wall is gone.
Even though i know that proper prepwork will equal the best results i m always looking for a shortcut because there s only so many hours in the day and i always.
Apply the mud to each wall that you will be applying the wallpaper to.
The best way to smooth out your wall is by skimming it with a joint compound.
Measure the length of the.
Smooth it over the wall using up and down and side to side motions until it s even and you ve covered the entire wall.
Slide the wallpaper into position lining up with the plumb line.
Brush the paper thoroughly with a wallpaper brush to eliminate any air pockets and to ensure adhesion.
How to hang textured wallpaper step 1.
Once the walls have dried take a.
I have never wallpapered before.
Use a mud knife to generously smooth the.
Create an new look with paintable textured wallpaper with the help of textured wallpaper and wood trim and a bunch of paint we transformed a blank.
Wallpapering directly over textured walls will result in some very unattractive bumpy wallpaper.
Remove excess paper with straight edge and razor.
To be completely honest i didn t want to put any extra work into this project other than the wallpaper itself.
While you should never wallpaper over any surface that isn t perfectly smooth there are some steps you can take to transform your textured wall to a smooth wall.
How to wallpaper textured walls.
Gently press the strip to the wall with a smoothing.
Wallpaper must be damp when hung and can drip.
Would you be surprised if i told you.
Measure the width of the paper minus 1 2 inch for overhang from a corner this is where you will begin.
Cover the floor of the room you are papering with drop cloths.
Most people suggested skim coating the walls with joint compound and painting them white but i really didn t want to put that kind of prepwork into it.
Take the strip of paintable wallpaper to the wall and line it up with the previously drawn line.
Allow it to dry thoroughly.
Apply the top half of the strip to the wall slightly overlapping the ceiling and adjoining wall.
Ok once with my dad when i was around 10 i think but that probably doesn 039 t count.
Fill a mud pan with a generous amount of sheetrock mud.
Do you use the roller to apply the liquid starch to only the strip of the wall you are working on and then roll it on to the back of the wallpaper for textured walls.
Press it up against the wall with about 3 inches of overlap on both the top and bottom.
Should the liquid starch be applied liberally to both areas.
Skim sand fill a mud pan with joint compound and using a putty knife apply the compound onto the textured wall.