Follow the instructions included with your grab bar kit.
How to install bathroom shower walls.
Put the grab bar on the wall and tighten the screws with a screwdriver.
Before you lay the field tile determine where the accent and border tiles will go.
Install the shower handle showerhead and tub spout according to the manufacturer s instructions.
Make a diagram of each wall to help you decide placement of tiles image 4.
If the wall is tiled stick in the wall anchors and hammer them to be flush with the wall.
Place a piece of cardboard in the shower base to protect the finish.
Along the studs mark the top edge of the base on all three sides.
In our project one wall is 31 inches and the other is 36 inches.
Set the tile panels on the side walls with thinset the same way as for the back wall using the starter board.
Install the backer board.
Measure the width of the shower walls on either side of the door.
If the wall is not tiled use the heaviest wood screws that will fit into the holes in the grab bar.
In our project we used white subway tiles in the field areas and green glass tile as an accent border for the shower area and walls.
Everything you need to know to install a direct to stud shower enclosure.
Caulk around the top of the shower the seams between panels the sides and the bottom where the walls meet the tub.
Shower area prep dry fitting the shower making plumbing holes installing the base installing the panels caulking and sealing and finishing exposed walls.
Set the cleaned tiles into the adhesive bed aligning the grout joints with the existing tile.
Make sure that trim pieces cover any exposed holes.
Now dry fit the enclosure.
Choose a backer board that s the same thickness as the drywall so you have a seamless transition from one to the other.
Use plastic spacers between tiles to maintain uniform grout lines.
Set the tile panels on the side walls with thinset the same way as for the back wall using the starter board.
You don t need to use a backer board in the entire bathroom just in the wet shower area.
Dry lay the panels and measure them to see where you need to make cuts.
Put the back shower wall in position locking the bottom tabs into the base.
Let the adhesive dry then grout the tile with a grout that matches the original tile.
In our project one wall is 31 and the other is 36.
Measure the width of the shower walls on either side of the door.