Install vent as close to roof peak as possible.
How to install corrugated roofing panels.
Use the corrugated molding strips on the horizontal cross braces and the rounded ones on the vertical rafters.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
If yours do not then you will need to drill holes.
For a secure and attractive finish you should use molding strips on top of the rafters.
Measure from the top of the roof down to the ridge and divide by six which is the height of the metal panel to.
Allow for a minimum of 18.
Attach the moldings using galvanized nails to prevent rusting in case of any leaks.
Measure the ridge of the roof to determine how many panels will be needed for installation.
Adjust door construction to desired size.
Before you start to install corrugated metal roofing you need to figure out how much you need.
Cut the panels to the desired length.
Measure the length of the roof and the breadth of one side.
Using galvanized nails attach the moldings.
Some panels have pre drilled holes.
This will prevent leaks that lead to rusting.
Pre drill holes on the ridges.
How to install corrugated steel roofing panels step 1.
Run a tape measure.
Use the rounded molding strips on the vertical rafters and the corrugated ones on the horizontal cross braces.
Place the first screw.
Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof.
For an attractive and secure finish use molding strips over the rafters.
Powtoon is a free.
Installing corrugated roofing 1.
Cut to fit pitch of roof and around vent.
Apply front and back panels similarly to side walls.
Install the roofing screws vertically along each rib in the panel.
Most panels come up to 32 feet 9 8 m in length.