Step flashing on roof peak.
How to install flashing on a roof edge.
Start the installation at the lower edge of the roof and work your way up toward the peak.
If you do not wish to form your own corner flashing you can buy pre bent pieces and cut them to size or use a piece of corrugated aluminum which is easier to bend.
Cover the nail heads with roofing cement and stick the felt down.
Bend the corner flashing tightly around the corner.
Select enough lengths of.
Install the step flashing when the siding is installed it should be tucked behind this piece and then consecutive courses lapped over it.
The drip edge should be nailed beneath the builder s felt but over the fascia board.
Drive the nail through the drip edge into the roof surface not through the fascia.
Roof shingle over step flashing.
The remaining siding on the sidewall will overlap the step flashing and nail.
Lift the shingles and slide the top flange of the drip edge underneath.
How to install drip edge flashing on a roof step 1.
Tack the edge in place with a roofing nail every foot or so.