At one side of the doorway slip the vertical track onto the rollers of the first door section.
How to install garage door installation.
Attach weather stripping to the bottom edge of garage door.
Lay weather stripping over the bottom door panel.
3 install the rollers and any necessary brackets on the garage door section and any wall or jamb mounted brackets according to the manufacturer s directions.
Screw cable brackets to the door to secure the weather stripping.
Center and level the first section after you install the brackets.
Installing a garage door step 1.
At a home improvement store purchase some rubber weather stripping.
You ll need to release the tension in the torsion spring before you begin working on the garage door.
The door must be level even if the floor isn t so use shims under the section to level it.
Use impact driver to mount hinges to the bottom panel of garage door.
How to install a garage door step 1.
Placing the first panel and track 1.
Insert rollers into the brackets attached to the door.
Stand the bottom door panel on the floor in the garage doorway.
The rubber gasket on the bottom section will fill the gaps created by an unlevel floor.
Once the piece is in.
Repeat at the other side.
To hold the level in place tape it to the section.
Insert the bottom piece into the door frame and use a level to properly set the piece.
Install the second.
Use a tape measure to carefully record the length and width.
Begin installing your new door.
Measure the various areas where the door will be installed.