Connect the interior doorknob to the door if you don t have a faceplate.
How to install interior door handle.
Chisel out the faceplate outline with a chisel and hammer.
Trim any exposed shims by scoring them with a knife and then breaking along the line.
Setting the door handle 1.
Make sure you purchase one that will fit correctly in the space left by the old doorknob.
The latching assembly that came with your new door handle should match the assembly on your old one.
The spring operated bolt with a beveled face to permit a latching action when the door closes.
If the doorknob is on the left you need a left handed door.
If you re installing a pre hung door make sure you get the correct swing determined by the placement of the hinges and doorknob.
Take your interior knob and align the holes in the knob with the bars on the exterior knob.
This video includes the removal of the old handle and the complete installation of the new one.
If you re installing a handle with a lock on it make sure you buy one with the locking mechanism on the correct side.
Step 2 remove latch mechanism take out two screws setting in the door edge and slide latch mechanism out.
The bars from your exterior knob should poke out onto the other side of your door.
If the knob is to the right select a right handed door.
Drive 6 finishing nails through the trim and into the studs behind the wall spacing the nails about 16 inches apart.
First take out the old door handle assembly by unscrewing the two screws that secure the assembly.
With the latch assembly in place slide the door handle with the attached cylinder into place.
Open the door and stand with your back to the hinges.
It must line up with the holes in the latch assembly to function properly.
Place the chisel at a 45 angle and begin to chisel the.
Screw the faceplate into the.
This is the exterior portion of your hardware with the spindle extending from the back.
Set the latch of the door handle into its hole and make distinct marks to.
Cut and install the trim on the second side of the door.
Installing a door handle is a relatively easy diy project.
Nail the trim to the jamb and studs.
Once you line them up press the interior knob onto the bars until the knob runs flush with the door.
Turn each screw several times apiece alternating to stop one screw from binding by being removed further than the other one.
This is the kwikset venetian bronze door handle set.
Watch this step by step video guide from bunnings warehouse and learn how to make sure the handles.