First clean out your gutters of any rocks or leaves that may be inside of them.
How to install rain diverter on roof.
Slide the diverter in.
Exposure at the other end to create a drainage pitch.
Slide the diverter under the row of loosened.
Lift the shingles to nail the.
Next gran the gutter guard and place it between your roof and the gutter.
Climb a sturdy ladder and locate the second row of shingles closest to the roof edge.
Slide the long side of the diverter under the shingles leaving the lip of the diverter hanging out.
Thick bead of clear silicone caulk on the underside of the drip edge lift the shingle tabs up slightly and slide the diverter under the tabs.
Using a pry bar or putty knife loosen the second row of shingles up from the edge of the roof where the diverter will be located.
A drop of 1 is plenty for a 6 diverter.
Loosen up the shingles by.
Slide one end of the diverter tight to the bottom of the shingle tabs and leave a 1 in.
Roof rain diverter installation steps sand underside of flashing with 80 grit sandpaper to help paint adhere.
Use flat pry bar to loosen stuck roof.
Start by cutting the flashing with tin snips about 2 3 feet longer than the doorway you want to protect.
Gutter guard is a mesh type of metal that is flexible and easy more.
Slide the diverter under the shingles.
Next carefully break the seal on a row of shingles above the doorway with a flat pry bar or putty knife.
How to install a rain diverter on a roof 1.
Slant the diverter so that one side is slightly lower than the other to allow for drainage.