Step 6 make a 10 degree bend on the shingle edge of the flashing approximately 1 2 inch from the edge.
How to install roof flashing against a brick wall.
Each flashing job is a little bit different and depends on the type of material that the exterior of your house is made of.
Do not fasten the flashing to the wall because it must float with the roof.
To install the roof wall flashing above the builder bent the top edge of the flashing into a 90 degree lip about 2 cm in width.
Follow the photo for illustrated instructions.
Most flashing is 8 inches wide.
Place the first step flashing strip over the end of the starter course shingle and use two nails to fasten the step flashing to the roof with 2 nails.
The wall leg of the kickout should be applied over the housewrap cut a 2 ft square piece of housewrap and tuck one edge into the horizontal cut the same one the first piece of housewrap was slipped into and up under the housewrap on the wall by at least 5 in.
If the roof runs flat up against the brick wall you must install the roof side of the flashing either under the last layer of shingles or over the roof material if it is metal.
Step 3 flashing angled roofs with the step method you can use the step method to flash an angled roof.
Flat roof and flashing against brick wall install base flashing under shingles or over metal roofing material.
Now install the kickout flashing and step flashings up the roof as needed.
You have to install the roof side of the flashing either under the last layer of shingles or over the roof materials if the roof runs flat up against a brick wall.
Use the metal break tool to bend the flashing lengthwise in the middle according to the angle of the roof joint.
You need step flashing which is metal flashing that is in an l shape.
