Spread the adhesive with the smooth side of your notched trowel and then go over it with the notched side to create ridges in the adhesive.
How to install tile on sheetrock wall.
If existing tiles are beyond repair remove the tile and install a piece of wallboard in its place.
Measure up from the bottom of the wall the height of the tile.
Repair any loose or cracked tiles.
Step 3 install the tile.
Wipe down with a damp cloth to remove any remaining dust and allow to dry.
Step 4 place tile adhesive on the sheetrock.
Sand the area with medium grit sandpaper and vacuum up the dust.
Set the second tile next to the first sandwiching two 1 4 inch spacers in between for even spacing.
Can tile be directly installed to wood surfaces or foam insulation.
Place the level horizontally on this line and.
Plywood and osb are not suitable surfaces for installing tile on walls and foam does not have the tensile strength to support tile.
Line up the tile edges with the vertical and horizontal marks on the wall to ensure that they re level and plum.
Be sure to put spacers between each tile as you go.
Wash the wall with tsp tri sodium phosphate or an ammonia based cleaner to remove any grease or oil.
Clean the surface thoroughly and allow it to dry before applying the thinset to sheetrock.
Spread the adhesive evenly in small in sections since the adhesive can dry before you lay any tile if your work area is too large.
Set the first tile next to where the vertical and horizontal lines meet on the wall.
To do so make sure all of the tiles are intact and secure.
Take care not to cover your lines.
Sheetrock is the trademark of the gypsum company.
Follow the manufacturer s instructions for using the thinset.
Remove the tile and prepare the wall according to the corresponding instructions above or tile over the existing tile.
Starting in the center on one side of your reference line apply a coat of tile setting adhesive to an area about 3x3 feet square.
It doesn t need to be paint ready and blemish free but it needs to be smooth.
Once you spread the mortar press the tiles into place.
Seal seams on new drywall with drywall tape and compound and let dry.
Bare gypsum drywall is a suitable substrate in all dry interior applications.
Add another 1 8 inch to the height measurement and place a mark on the vertical line.
Use long sweeping motions to apply mortar to the wall and start placing your tiles in the marked locations.
If the sheetrock is in an area that does not encounter a lot of moisture it is fine to use thinset to install tile.