To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall.
How to install tongue and groove paneling on walls.
Avoid visible nail holes install planks with the tongue up.
Measure and mark every 16 inches vertically on the.
Remove any old trim from your walls.
Nail up the first panel at a corner of the room with the tongue side facing out.
Install furring strips running horizontally across the wall if you want your tongue and groove boards to run up and down rather than sideways.
As each section of tongue and groove wall paneling is installed don t worry about stud rafters overrun.
Secure sections with a nail on the tongue and simply slide in the next cut when you need one.
Secure the first row by nailing into the tongue to the joist or furring strip and secure the groove side of the plank by face nailing into the joist.
If it doesn t line up to the stud rafters the end matching ensures that you won t have any problems.
Snap a chalkline or use a straight edge and mark a line on all studs so you know where to put your nails.
Popular throughout the 1960s and 1970s wooden wall paneling or tongue and groove paneling is still widely used today to create a rustic traditional or even retro look in the home.
Use a stud finder or knock or drill holes until you find the studs at the top and bottom of the portion of wall you are going to install your planks on.
By using paneling materials with tongue and groove joinery like that found in hardwood flooring you ll find the installation is fairly easy requiring only simple tools.