At ryan they also have flashing called a gutter apron which actually is about 1 11 4 which and has a lip also on it.
Install apron flashing gutter.
A gutter apron is a long piece of metal fold that starts under the first course of shingles and hangs over the sheathing of the roof.
Finish your roof line and protect the fascia board with the amerimax 10 ft.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
White aluminum roof apron flashing.
First step flashing must be installed before the siding so that the siding can cover the top of the flashing.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
Install by nailing under shingles.
The gutter lip and the apron lip go together so essentially you are extending the back of the gutter by 1 11 4 high.
Drop with 1 4 in.
Once the apron s in place fasten it with sheet metal screws.
Gutter aprons take on an additional role by hanging down an inch or so into the back of the gutter to prevent water from dripping or splashing behind the gutter.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
Gutter apron is installed over the roof edge and hangs in the gutter.
If this is a repair job the siding must also be removed and replaced with the flashing.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.
While a drip edge is about 2 1 2.
Measure all the sides of the roof line of the house with a tape measure and record the measurements.
It is put under the shingles of an attic to flow water directly into the gutter.
Nailing edge 1 3 4 in.
Gutter aprons take on an additional role by.
Climb up the ladder and pull back the shingles at.
Position a ladder on the ground at any corner of the house.
When it comes to gutter apron and flashing installation there is only one indianapolis area gutter apron and gutter flashing installation specialist that you need to rely on the most.
With gutter replacement you can prevent water from running behind your gutters by installing a metal gutter apron flashing under the shingles and over the back edge of the gutter.
Home centers sell rolls of 6 in.
The flashing helps guide run off away from shingles and into the gutters.
Protects fascia board finishes the roof line and guides run off into gutters.
Is it a proper install.
What is a gutter apron.
Gutter apron a specialized drip edge designed to direct water into the gutter system.
Irestore roofing restoration are the indiana experts in the gutter apron and flashing installation industry.
A couple picture are attached are there the proper aprons.
Second step flashing needs to extend 8 to 14 inches above the shingles according to the national roofing contractors association nrca.
Add all four sides together for the.
How to install gutter flashing.