How to install a drip edge.
Install gutter drip edge.
To install a drip edge on a newly constructed roof or on a re roofing job attach the drip edge along the roof s eaves first.
Home centers sell rolls of 6 in.
How to install drip edge flashing to a new roof.
If there s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge get some roll flashing and tuck it up under the drip edge and over the top of the gutter.
A gutter apron is installed on the corners above roof decking.
A drip edge is a non eroding stainless material that is placed on the edge of the roof.
This is important to protect damage to your fascia soffits rafters.
Make sure the outer edge extends over the gutter.
If the gutter is not behind the drip edge there is a chance that rain or melting snow may not fall from the edge of the drip edge but instead cling to the metal and run behind the gutter.
Installing drip edge on your roof.
Begin at the lower corner of the roof and gradually progress to the top.
A gutter apron is used where shingles are not far enough from the edge of the gutter.
Other causes of the water running behind the gutter if properly installed are roofing not extended 3 8 past drip edge improper overlap of drip edge ice.
Use tin snips to cut the gutter apron flashing roll in two 3 in.
Tools supplies tin sn.
With without rain gutters.
If it doesn t pull the drip edge out slightly from under the shingles.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
The roof leg should extend a minimum of 2 back onto the roof sheathing.
It is put under the shingles of an attic to flow water directly into the gutter.
Begin installation it is best to install a drip edge on a day with warm weather because it makes it easier for the shingles to be stripped back.
While the vertical leg should be placed 1 4 1 2 away from the fascia.
Raise the shingles and push the top rim of your drip edge beneath them.
While on the other hand a drip edge is installed to the trim and usually hangs directly behind the back of the gutter.