Its wires are held inside an electrical box that is connected to a metal light can.
Install recessed lighting in existing ceiling no attic access.
Insert the electrical cable into the cable clamp on the remodelling recessed light housing.
The housings and trim themselves aren t that expensive i picked up some 4 halo retrofit can lights for about 17 each from lowe s and trim for about 20 each at home depot.
How to install recessed lighting even without attic access materials needed.
But some homeowners may be reluctant to install them if they don t have access to attic space above the room where they would like to have the can lights installed.
Mark the spot on the ceiling where the recessed lighting fixture is to be installed.
If the area above the ceiling is a finished space you can insert a coat hanger or fish tape through hole to check for any obstructions.
Cut the cable with wire.
Recessed can lights are flush mounted with the ceiling.
Recessed lights commonly called can lights offer a pleasing finish to virtually any room and make for a reliable source of inconspicuous lighting.
When the can is installed into the ceiling clamps on the side expand securing the fixture.
Run electrical cable through the ceiling from the recessed light hole over to the light switch hole.
Pull the end of the cable out of the wall by 6 inches with fish tape.
Unfortunately though a retrofit installation for those of us without attic access can also get pretty expensive if you hire someone to do the work for you.
Use an electronic stud finder to locate two adjacent rafters and mark a spot half way between them as the.
Drill a 1 4 inch hole in the ceiling at the center of the proposed opening.
Without an attic recessed lights must be installed from below the ceiling instead of the top.
Remodeling recessed light housing is the required model for the project.
With a utility knife cut off 3 inches from the outer insulation jacket of each end of the electrical cable to expose the internal insulated wires and bare copper grounding wire.