Install the z flashing end caps item 4 using rivets item 16 install the gutter end caps item 7 using rivets item 16 install the gutter brackets item 8 install the gutter item 6 using rivets item 16 when installing the gutter secure the high end first and using a stringline allow a minimum fall in the gutter of 1 in 500.
Install z channel above gutters.
J channel comes in 12 foot sections and is either 1 2 inch thick or 5 8 inches thick.
Install the first length of z flashing.
It mounts the siding to the wall and helps hold the soffit in place.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
It can install on any type of house including wood or masonry.
This allows you to bend the center part of the flashing over the sides of the door to cover the.
Cut half inch notches into the z flashing on both ends where the flashing bends using the tin snips.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
If you didn t want to replace a lot of siding caulking the edge where the siding meets the z flashing might help keep that bottom edge from getting punk again but the problem with caulking it is that the flashing is supposed to let any water behind the siding to get out.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
J channel is a piece designed to fit over siding and soffit pieces.
Item 3807 model 5504900120.