To install corrugated roofing start by cutting your panels to length with an angle grinder.
Installing corrugated metal roofing.
It s important to start square because if the first panel is tilted a little bit all the panels that come after are going to be tilted as well.
2 corrugated metal roof installation instructions.
The sheets should overlap by at least four inches add a bead of caulk where they overlap and at the other end of the building ensure there s an overhang of two inches.
Once the first sheet is in place you need to install the remainder of the lowest row of corrugated metal roofing.
Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.
Metal roofing installation starts with fastening or screwing down the metal roof panels correctly.
Over tightening and under tightening fasteners pre drilling screw holes using the right tools and chalk lines.
Install the roofing screws vertically along each rib in the panel.
Insert about 20 nails into the humps of the ridges spread equally throughout the panel.
Powtoon is a free.
Finish the first side of the roof.
Buy the metal panels.
Work at a comfortable steady pace trying not to rip up or carry off too much old roofing at once.
Step 4 line up the second sheet overlapping the first by one ridge and install it in the same manner.
Lay the roofing felt.
This means that your vertical lines are all running square to your eave.
Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses.
In this article we discuss.
Lay and secure the first metal panel.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Remove the old roofing.
Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.
Although you can install corrugated metal roofing over shingles for the best foundation it is recommended that all the old roofing be removed.
Line up the first panel at the bottom corner of the roof near the lip and hammer it in place with 3 inch metal roofing nails.
5install metal panels or shingles.
Secure the sheets into place with screws.