Measure the fascia to determine the length of the gutter.
Installing gutter on not plumb fascia.
A standard fascia bracket will then be used to connect the rafter s front plate arm with a provided bolt and nut.
Drip edge gets installed under the first course of shingles and promotes water to run freely from roof edge down into gutter.
The correct placement of the drip edge is the top of the roof directly between the shingles and the fascia board.
Angled fascias can complicate things for do it yourself gutter installers.
Please ensure that the drip edge is extended over the gutter.
Snap a chalk line across the fascia creating the proper pitch toward the downspout end.
Below the shingles on the high side of the gutter run.
The drip edge should be installed over a furring strip so that it tails off the fascia board.
If the roof is older it is not wise to try and lift up the shingles to get the strap under because you can damage or break the shingle.
The roof straps attach to the hidden hanger inside the gutter and secure right into the roof.
To install gutters have the gutters slope downward toward the downspout so they work properly.
A home without fascia needs to have gutters attached by roof straps.
Secure the end cap to the gutter with a crimping tool.
Installing on a slanted raked fascia.
A house without a fascia the piece of wood below the last shingle has to have gutters installed using roof straps.
It should be a minimum extension of two inch from the fascia board on the roof.
Clogged gutters can result in runoff water which can damage your home and landscaping.
These straps act as a sling for your gutter.
Sometimes the roof needs repair in addition to the gutters but you aren t able to complete both projects at the same time.
Apply gutter sealant to an end cap then press the cap onto one end of the gutter.
Installing gutters in 18 steps.
Measure and record the distance from the bottom of the fascia board to this nail.
For every 10 feet of gutter from this measurement and mark this distance at the low end of the gutter run.
When installing gutters set the proper slope by driving a nail 1 2 in.
If the fascia board you re installing them on is longer than 35 feet have the gutters slope from the center to each end.
Without it water may run down behind your gutter down fascia board and siding leading to potential damage.
They re fitted to the gutter hanger and then they are attached directly to the roof.
Or if the fascia board is less than 35 feet long have the gutter slope from one end of the board to the other.
Side rafter brackets are galvanized metal arms which are fixed to the bottom side of your rafters.