Fitting the led strip light to the av awning.
Installing led awning lights.
Route the cord to your interior 12v source and plug it in.
Just measure your awning cut and mount your lights wire them in and you can start enjoying your newly lit outdoor living space.
September 4 2015 i recently decided to add a set of led strip lights to our trailer.
You can also try running your cords through the hole where the awning wiring comes out.
If possible drill hole right at end of light strip and no wire will show.
Remove the cover to the two sided tape and center the led on the awning arm.
Cover the exposed wires at the end of the light strip with shrink wrap.
As extra precaution you could put painters tape over drill location before drilling.
Next we re going to mount the second led light bar to the first.
Adding an led light strip to your rv awning buy how to hardwire awning lights led lights mod rv awning led light installation rv led strip lights rvgeek strip light.
Use new sharp bit and drill with modest pressure.
A video showing the installation of an led light strip under the awning on our rv.
Everything is now good.
Measure numerous spots below awning track so lights are in a straight line.
Under rv led pod light kit with 8 bright lights.
A much harder project is shortening your rv awning which is still very doable.
I was able to do this without any drilling into the tailer by utilizing th.
This strip can be mounted in many places however the best site for mounting the led awning light is just under the awning extrusion that is fastened to the sidewall of your unit please see pictures.
Connect and tighten the connectors over here and as i ve said before the awning arm is already prepped and cleaned to insure proper adhesion.
These very bright rgb pod lights cabels and control box are fully weatherproof.
Installing an rv led strip light.
And press again all along.
Do not use strip lights under a vehicle this is the correct way to get.
The best way to fit the led strip light onto the av awning is to use either super glue double sided tape or if the lights have been purchased with drilling holes drilling these onto the metal in the awning.
A full underlighting kit for your rv or other vehicle.