These nails are temporary so make sure not to drive them in all the way.
Installing ledger boarx to house for deck vynal siding deck.
Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.
The bottom edge of the flashing should be at least 3 so that is fully covers the ledger board and goes past about 1.
Step 2 cut away the vinyl siding carefully cut away the siding with a utility knife braced along the edge of the carpenter s square to avoid slicing through the house wrap.
In order to install the ledger board you usually need to remove the house s siding.
Make the outline large enough to include space for the deck boards on top the ledger and any trim boards on the sides.
It is certainly not a job for a weekend carpenter or diy er.
These 18 articles will teach you how to install flashing and bolt the ledger connection to the house rim.
A ledger relies on the fasteners and strength of the wood ledger board and rim board of the house to carry the deck live and dead loads.
Most house framing relies on building elements floors walls roofs being stacked one atop another.
Just imagine having to remove courses of masonry or lap board siding and then precisely locate the band board accurately to avoid damaging the wrong part of the siding.
Place the ledger board so that the lower edge of the ledger board is properly aligned with the lower edge of the cut siding.
You can use a couple of 16 penny nails that are partially driven in to hold the ledger board in place.
Then slip flashing behind the siding covering the top edge of the ledger.
As you can see the best time to install a ledger for a deck is during the house s construction and framing before the siding crew arrives.
But that is not always possible.
Learn the tools techniques materials and fasteners to properly install a deck ledger board arguably a deck s single most important connec.
Make the outline large enough to allow space for the.
Step 3 add 2 x 8 planks between joists.
Measure the length and width of your deck to attach the ledger correctly.
Locate the rim joist and mark an outline on the siding where you want to position the ledger board using a tape measure pencil and chalk line.
Snap a chalk line cut out the siding and tack up the ledger board.
It gets complicated in a hurry.
Installing a ledger connection to a house after it is constructed is a major job.
Aluminum and vinyl siding can easily be removed with tin snips from an area one foot surrounding the ledger board location.
