Mounting kit contents driver side mounting.
Installing licensce plate onto sheet metal.
Steel can be attached to concrete without screws or glue by using concrete anchors and bolts.
Screw the license plate onto the bracket.
To go along with.
When you re drilling into harder material such as sheet metal you need to drill a pilot hole in advance.
To save time and labor you can use self drilling self tapping screws to drill into metal.
You can easily measure out a 12 x 6 rectangle on your sheet of metal using a ruler and marker and guess at the rounded corners.
For thicker metal it may require more than one screw to drill through the surface.
Drive the screws clockwise through the holes to complete installation.
In this case there would be no way of removing it after it had rusted and broken down.
Using supplied connectors splice pop light wires into truck illumination wire as shown in figure 4.
Make sure license plate lights are working properly.
Alternatively you could cast the concrete with the metal embedded in the concrete.
While installing vertical metal siding is similar to installing horizontal siding there are a few differences you ll want to keep in mind.
Install pop lights into bumper figure 4.
Once the bracket is in place you can align its holes with the holes in your license plate.
Offence he will be delighted to add illegal plates onto the charge sheet.
Using square plastic grommets and sheet metal screws install license plate see figure 3.
I made a template out of cardboard but it s not necessary.
For those of you who were concerned about kevin and i running around illegally with no 3rd brake light or license plate light have no fear.
The license plate frame i have will hold a plate and matches its stock bolt holes.
Actually i got away with a warning but it could have.
This is not the best approach because the metal will rust when embedded in concrete.
There is no such thing as pressed metal plates that are legal.
A license plate is 12 wide by 6 tall with rounded corners.
Fortunately with the right tools and preparation putting vertical metal siding up on a building can be a smooth and simple process.
Although these screws are more expensive they re capable of.
