Measure the roof area.
Installing metal roofing step by step.
Measure the roof with a tape measure to determine the number of panels needed.
6 simple steps for metal roof installation step 1.
Install corrugated panels either on solid decking or strip sheathing which are 1 by 4 inch boards nailed.
Measuring and acquiring the metal panels or shingles start off by measuring the area of your roof.
You first measure the roof s width and length then add the desired overhang measuring from the lowest.
For exposed fasteners avoid over tightening the fastener.
Place the first screw.
Adhere the shingles adjacent to the flange with roofing tar.
If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof.
The panel used in this example is a 16 inch coverage panel with a nail flange.
Exposed fastener installation step 1.
Getting the right result will help you determine the right amount of metal roofing material you ll need to order.
Step by step guide to installing corrugated metal roofing step 1.
You will need to order enough metal material to cover the entire roof and this process.
Installing a standing seam metal roof is not as easy as it may seem at first.
Take the metal panels one by one and place them on the roof.
Prepare the foundation it is crucial to prepare the foundation prior to installing the metal shingles or panels.
We will show you how to install these metal panels with both exposed fasteners and hidden fasteners.
Adhere the joint where the cut edges of the shingles meet the dome with roofing tar.
Install the roofing screws vertically along each rib in the panel.
Installing the roof step 1.
Try to buy panels in lengths that.
You ll want to order metal panels that are an appropriate color and look to complement your.
Standing seam installation process can actually involve a lot of tedious work so let s cover it in a step by step.
Yeah you might think.
Start by installing the edges.
When you re installing a metal roofing panel the first thing that you want to do is make sure you re starting square.
Use your neoprene washer head screws to secure the metal to the sheathing.
Remove the old roof.
The first step to installing a metal roof is to take an accurate measurement of your roof s height length and width.
Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.
Align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof.
Not so quick now.
This is the most critical step.
Attach he ridge cap shingles with two nails each.
Use the 1 25 inch nails to secure the metal strips on the flashing.
Space the screws about 12 in 30 cm apart.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
Trim the shingles away from the ridge vent hole.