In this situation safety compliance for the crew is critical as the technicians will be working with no decking or sheathing beneath them.
Installing metal roofs panels.
Having a proper job specific safety plan with 100 percent tie off rule is a good recommendation.
With many color and profile options metal is a great choice for any architectural scheme.
The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof.
You can learn more about installing eave trim and offset cleats in another one of our metal roofing installation videos.
Low slope metal roofs are often installed as structural standing seam panels over open framing.
Next you are ready to install the metal roof.
Install the roofing screws vertically along each rib in the panel.
At this point chalk a line from ridge to eave.
Always begin working at the point with the longest peak to eave distance.
1 remove the shingles before installing the metal roof the first way to install a metal roof over shingles is by completely removing the old shingles before installing the new metal roof.
Install metal panels or shingles align the first metal roofing panel so that it overlaps the edging by 1 2 to 3 4 of an inch and is square to the roof line.
Place the leading edge of the first panel along this line.
Whether you are looking to install a new metal roof or repair an existing roof or siding on your.
You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.
You can use 1 inch nails for the installation of eave flashing.
Take your first sheet of metal and place it on the roof so that it overhangs the edge at least 3 4 in 1 9 cm.
Be sure the larger edge is laid so that the small edge of the next panel will overlap it.
Install the offset cleat along the eave and then you are ready to install the metal roofing panels.
The offset cleat allows us to create a true hidden fastener installation.
Metal roofing is an excellent choice for re roofing projects because metal panels can be applied over existing shingles and other roofing material.
A benefit to doing it this way is that you can see if there is any rotten plywood that needs to be replaced before installing the new roof.
Add the metal panels.