Measure the width of one block wall and cut treated two by fours to match.
Installing siding on concrete block.
At the top of a furring strip drill a hole.
The vinyl siding that around the concrete portion that i want to cover up is attached to an osb board that s attached to the framing of the house.
There are hundreds of colors to choose from when you decide on installing vinyl siding.
Attach the boards to the block by holding them in position you ll need an assistant and drilling through the boards and the.
Foam insulation in between.
Line up the hole in the strip with the top hole you drilled in the wall.
Vinyl siding colors are not restricted to the limited five or ten pastel colors that were the choice for so many years.
How to install siding on concrete block house step 1.
Install the boards horizontally placing them flat against the.
Installing 2 inch wide treated strips is necessary for a solid base for the house siding.
As a result the osb protrudes about a half inch farther out than the concrete.
The information that i have found states that i should use 1x3 furring actually 3 4 thick.
In effect i would need to add a bit of spacing between the concrete and the siding.
My workshop walls are concrete block.
They re functional but ugly so i installed fibre cement sheets over the block with the help of timber studs.
I have trimmed out the windows and capped with coil stock.
Install a strip of insect netting along the bottom edge of the concrete wall by nailing the netting to the.
Place the strip so its center is lined up with the vertical line.
Nail 1 1 2 inch thick wooden furring strips to the concrete wall at 4 foot intervals using concrete nails.
If your wall has windows doors and other obstructions keep the furring strips away from them.
Position the boards to the top and bottom edges of the wall.
I m not a.
Using self tapping screws such as those by tapcon will fasten the strips to the concrete securely but concrete nails can be used as well.
Insert a sleeve anchor into this hole and tighten the anchor enough to hold the furring strip in place.
Installing siding over concrete block.
The strips can be ripped from 2 inch by 4 inch lumber or plywood but they should be at least 3 4 inch thick.
I have a block house and will be installing vinyl siding over the block.