Wider siding should be face nailed using two nails per piece.
Installing tongue and groove siding.
With tongue and groove planks each piece has a side where there is a groove cut along the length of the board and a side where a tongue runs the length of the board.
How to install a tongue and groove ceiling installing tongue and groove aka t g boards is a fast inexpensive way to panel any ceiling or wall.
Step 2 prep wall surface.
You may choose to install corner trim first and butt the siding up to it as shown.
Secure sections with a nail on the tongue and simply slide in the next cut when you need one.
Tongue and groove siding can be installed horizontally or vertically.
How to install tongue and groove siding part 1 step 1 determine the amount of siding needed.
Once all the supplies are obtained siding included you still aren t quite ready to begin the.
Most of the tongue and groove you ll find at home centers and lumberyards is 1x6 or 1x8 spruce.
If it doesn t line up to the stud rafters the end matching ensures that you won t have any problems.
The paneling will be nailed directly to these furring strips.
Tongue groove installation tongue and groove siding can be installed horizontally or vertically.
Siding up to 6 152mm wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.
Before beginning a siding project you must first ascertain how much.
As each section of tongue and groove wall paneling is installed don t worry about stud rafters overrun.
If you want the trim to be more pronounced install the siding first and then apply the trim over the siding.
The stales are installed every 12 into the tongue of the board and are covered and hidden by the next boards groove is installed.
In horizontal applications start at the bottom and work up with the groove edges facing downward to assure a weather tight wall.
To install tongue and groove paneling vertically begin by nailing 1 by 3 furring strips horizontally either directly to the wall studs on a new wall or over the drywall on a finished wall.
In horizontal application start at the bottom and work up with the groove edges facing downwards.
I chose to install my wall with the tongue side facing up and the groove side facing down.
When installing being by nailing one board to the top of the wall.
We used 1 1 4 long 1 4 galvanized staples to install this cedar.
Nail up the first panel at a corner of the room with the tongue side facing out.