Stratco fascia is easy to install.
Internal gutter brackets installation.
Once the gutter section is aligned with the chalk line drive the long screws attached to each bracket into the facia board of the house to hold it securely in place.
Run a bead of silicon caulk between the gutter sections to prevent water leaking through the seams.
Then the next piece slips into the seaming bracket and the process repeats until you reach the end of the area to be covered.
With all the necessary fittings attached to this length of gutter install a hanger bracket every 2 to 3 ft.
Internal gutter straps hold the face of the quad guttering into position.
Our gutter protection doesn t damage your roof or void your roof s warranty because of our unique method of attaching them to your gutters.
Tip the hooked end of the bracket under the front flange and press the remaining end over the back fo the gutter.
The usual way to finish a run of guttering is to bring the gutter past the end of the tiles or slates and then fit an external stopend which clips directly onto the gutter and forms a watertight sealed end.
If using external brackets install the brackets on your fascia then mount the individual sections of gutter onto the mounting brackets.
Stratco gutters can then be installed using the stratco gutter suspension clip which attaches the gutter to the fascia.
They are installed internally at a maximum of 1 2 metre intervals and are not visible on the external face of the gutter.
Our gutter protection attaches directly to your existing gutters using internal brackets and self threading screws.
Specially designed fascia brackets attach to the rafters then the stratco steel fascia is simply clipped into place.
Make sure the fall is set towards your downpipes with a stringline then install the clips into timber fascia using flat headed bugle screws.
Join the sections with gutter connectors.
Attaches directly to your existing gutters.
Stratco fascia is lightweight easy to handle.