Double check to be sure the door opens in the desired location and direction.
How to hang a prehung garage door.
Set it in the rough opening then level shim and nail it.
When the fit looks right apply pvc cement where the middle piece will overlap the corner pieces and press it into place.
Avoid damage to the screws by using a hand screwdriver.
The door should be square.
Remove the screws or nails that hold the old frame in place.
Some kits come in three pieces to better fit the opening.
Remove the old door.
Prehung doors hang on a jamb that is split into two pieces.
Install a drip cap or z flashing above the opening.
If there s interior trim remove that from the door as well.
Check out these easy to follow tip on how you can install a pre hung exterior door.
Use shims on the side of the door with the hinges to remove the gaps between the trimmer stud and the door frame.
Place door shims at the top and bottom hinge locations using a long level or a straight board and a short level.
Complete the installation.
Typically both jambs are furnished with casings already attached.
To install set the corner pieces on the sill then place the middle piece over top.
Have another person hold the pre hung door in place while you install wooden shims where necessary.
Check out these easy to follow tip on how you can install a pre hung exterior door.
Install latches door handles and other hardware.
Slide the pre hung door into the rough opening.
With all the screws out take the door from the frame and trash it.
Cut off the shims at the edges of the jambs.
Starting at the bottom take the hinge screws out of the jamb.
Take out the fasteners.
The split jamb has a groove under the stop so it can slide over the edge of the main jamb.
Then add the center door shims.
The door is attached to the main jamb which is installed first.
The top leg should slide up behind the housewrap or tarpaper that s behind the siding.
If it s too wide cut the ends with a hacksaw.
Using shims avoids the necessity for rebuilding the door opening to fit the pre hung door.
Put the door in the opening and slide it until the jamb is flush with the wall.
You already know the standard approach to hanging a door.