All you need is 1 2 5 x 5 8 corner brace 2 1 4 20 hex jam nut and 1 1 4 x 1 5 carriage bolt.
How to hang deer skull on the wall without nails.
Then tighten down the bolt.
Hang your deer skull with an adjustable skull hanging bracket stepping it up a level displaying a european deer mount on the wall gets a little more interesting when you have freedom of the angle you display the skull at.
Just make sure that the clothing.
Use screws measuring approximately two inches longer than the depth of the wooden plague.
Feb 20 2014 8.
I prefer level right hangers and drill out the plywood behind the hanger so the scew head can be any distance from the wall and still allow the mount to hang tight against the wall.
In a house that old you re asking for trouble.
By hand bend the corner brace about 10 30 degrees to get the desired angle.
In this case you use a skull hanger to position the skull to the angle of your liking.
Trophy specialist apr 21 2011 apr 21 2011 6.
Works really good on all kind of skulls.
The fourth and final step to a european mount is to actually mount display the deer skull.
Insert your bolt through the panel place the wing on the bolt and insert that into the hole in the back of the skull.
Mark the placement for two small holes on the back of the steer skull directly behind the eye sockets.
We decided that our pump house looked a little plain and we needed to find something to decorate it with.
My wife remembered that our son had found a cow sku.
I am using a standard utility or clothing hook to mount the skull.
Use locktight on the two nuts to keep the bolt in place and you can paint them a flat black to be less conspicuous if desired.
Place one screw at the top of the skull and drill slowly to prevent cracking and splitting the skull.
Run a 3 inch screw horizontally at the ceiling and attach your rope wire there.
Use a drill bit slightly smaller than the screws so that the screws do not slip or shift after the skull is mounted on the wall.
A mount will hang much more secure when it is tight to the wall too and they also look better too.
Drive a minimum of two drywall screws through the wooden plaque and into the back of the deer skull.
You could use a ring from a key ring or even.
Drill a small hole into your panel so the skull would be centered on the panel.