Slip in the flashing.
How to install kickout flashing on existing roof.
Cover with cap flashing.
Nail it to the sidewall or glue it if nailing isn t possible.
Lift the bottom shingle and slip in the kickout flashing.
Step 3 install the kickout flashing.
Peel and stick along the edge of the roof and lap over top of fascia.
Step 3 install the flashing.
Here s the solution step 1 waterproof the wall.
Align the back side of the bent kick out flashing with the step flashing and shingle attached to the vertical wall.
Next install a course of peel and stick membrane along the eaves.
Stick top edge of transition strip membrane to fastflash.
Apply waterproofing membrane where the bottom of the roof meets the wall 1.
Step 2 flash the roof and roof wall connection.
Use roofing nails to install the l shaped flashing flush with the roof and wall then cover it with roofing cement and reattach the roofer s felt.
Place the back edge of the kick out flashing over the caulking and attach with a galvanized nail to the vertical wall.
Learn how to install kickout flashing and help control water management from the roof into the gutter with this instructional guide from james hardie.
Run a small line of caulking down the end of the adjacent step flashing.
Finally reattach all shingles removed in the process.
Install fastflash along the wall at the roof edge.