Use a square and pencil to mark the gutter length and cut to the line.
Installing gutter pops.
Snap the sections together.
Cut a two inch long notch in the front lip of the gutter with tin snips to join a rain gutter section.
Firmly hit the top of the nails with a hammer to drive them into each point.
Project step by step 20 cutting the gutter.
Then trim the first section of the gutter to length with tin snips.
Begin by installing a slip joint splice on each end of an inside corner fitting.
We provide a fully licensed plumber to do all your gutter.
Dig a hole underneath your gutter downspout and place a catch basin in the hole.
Slide the splices on as far as they ll go.
Secure it with eight pop rivets or sheet metal screws.
Snap a chalk line between the start and end of the gutter run.
How to install a pop up gutter drain.
Cut a triangular section from.
These drains are attached to the end of a pipe that runs underneath the surface of your yard.
Locate the endpoints and hold a nail over each.
Form strip miter joint at corner cover the joint between two lengths of gutter at each corner with a strip miter a 3 inch wide strip of aluminum.
It s much easier to join sections on the ground than to work from the top of a ladder.